News

If your remote does not seem to be functioning properly, or if you have replaced the battery and the remote no longer controls the functions on your seed tender, you can easily pair, or re-train the remote to restore proper operation.

• Power on the unit.
  • The LED on the receiver will flash red four times.
  • Place a fairly powerful magnet over the, "L" on the receiver for approximately 3 seconds and then remove the magnet.
    • The LED will change from flashing red to constant red.
    • Press any of the buttons on the remote FOB.
      • The LED will change from red to green/yellow.

Once the LED changes to green/yellow, the remote will be paired to the receiver and should operate normally.

You can also watch a video explanation.